823
14
A 2-part Urutau upper designed for AR-9 barrels.
The upper itself should be printed with the same settings at the normal upper, the sleeve should be solid and (optionally) printed in Nylon (to shield the upper from barrel heat). Unlike using my sleeve and the normal upper, this one will prevent the barrel from spinning (I had issues with it spinning when trying to remove my fake can).
LBRY Tags: urutau; ketcham1009; ar-9; 3dprinting; fosscad
The upper itself should be printed with the same settings at the normal upper, the sleeve should be solid and (optionally) printed in Nylon (to shield the upper from barrel heat). Unlike using my sleeve and the normal upper, this one will prevent the barrel from spinning (I had issues with it spinning when trying to remove my fake can).
LBRY Tags: urutau; ketcham1009; ar-9; 3dprinting; fosscad
Related to This Release
4637
52
1
UBAR-9 Lower Receiver
One of the strongest printable AR-15 lower receivers is now available in a 9mm PCC variant!
LBRY Tags: firearms; 3d printing
381
11
Urutau AR-9 barrel Un-Floater v1.1
I wasn't comfortable leaving the AR-9 barrel for the Urutau floating/unsupported. This bracket snaps in to the upper receiver and supports the barrel…
324
12
Urutau AR-9 barrel sleeve and shim v1.1
A sleeve and shim meant to reduce the movement of an AR-9 barrel in the Urutau.
I recommend printing the sleeve in nylon or some other temperature r…
319
9
Urutau Fake Can - AR-9
A fake suppressor for Urutaus that have a 16 inch AR-9 barrel. It attaches to the barrel threads.
The 'front' of the fake can is intentionally left t…
145
7
Harlot tilt limiter frame
A set of left and right frame parts that limit the tilt of the harlot's barrel to roughly 50 degrees.
LBRY Tags: 22lr; pistol; ketcham1009; 3dprinti…
Twitter
Matrix
Source
