for HK P30 VP9 P2000 magazines for the magpump

the way HK does their magazine releases are sub optimal. Also gay because HK is a gay company.

for my own print I used polymaker PETG with the standard .3 settings with a .6mm nozzle.

no supports needed even with PETG.
the magazine sleeve lug recess was not supported and mine printed without issue, its a much larger bridge than the magazine release lugs.

Inserts just like the other magpump magazine sleeves
Put the magazine in at an angle and then drag it until the lugs engage with the magazine lug recesses
Push the sleeve in until the magazine sleeve lug enganged with the sleeve release, it should be fairly solidly in the magpump at this point
load as you have before, you will see the magazine move a bit but it shouldn't cause any issues.

guncadindex tags:
9x19mm
magpump
HK P30
HK VP9
HKP2000

LBRY Tags: 9x19; magpump; hk vp9; hk p30; hk p2000