13
2
View this release
Alternative links
Ruger Max-9
for my own print I used polymaker PETG with the standard .3 settings with a .6mm nozzle.
no supports needed even with PETG.
the magazine sleeve lug recess was not supported and mine printed without issue, its a much larger bridge than the magazine release lugs.
1. Inserts just like the other magpump magazine sleeves
2. Put the magazine in at an angle and then drag it until the lugs engage with the magazine lug recesses
3. Push the sleeve in until the magazine sleeve lug enganged with the sleeve release, it should be fairly solidly in the magpump at this point
4. load as you have before, you will see the magazine move a bit but it shouldn't cause any issues.
guncadindex tags:
9x19mm
magpump
Ruger
max-9
magazine
for my own print I used polymaker PETG with the standard .3 settings with a .6mm nozzle.
no supports needed even with PETG.
the magazine sleeve lug recess was not supported and mine printed without issue, its a much larger bridge than the magazine release lugs.
1. Inserts just like the other magpump magazine sleeves
2. Put the magazine in at an angle and then drag it until the lugs engage with the magazine lug recesses
3. Push the sleeve in until the magazine sleeve lug enganged with the sleeve release, it should be fairly solidly in the magpump at this point
4. load as you have before, you will see the magazine move a bit but it shouldn't cause any issues.
guncadindex tags:
9x19mm
magpump
Ruger
max-9
magazine
Related to This Release
200
13
380 Decker Single Spring Short Magazine
This magazine is just a short version of the original decker magazine. It uses the same main spring, but only one.
It does not function any better t…
44
6
MagPump - Beretta 92 magazine sleeve
This is a sleeve to adapt Beretta 92 magazines to the Magpump. I do not own a Beretta PX4 or a CX whatever but I have heard the magazines are similar…
37
2
FNX-45 magazine baseplate
This is the baseplate for the fnx-45 reverse engineered from the rocker mag baseplate. I had intended on using this on the 545 .45 18rd mags as a ful…
34
2
Magpump - hellcat magazine sleeve
This is a magazine sleeve to make the magpump compatible with the Springfield Hellcat
README
for my own print I used polymaker PETG with the standa…
240
3
AR-9 Prof. Parabellum V1.2
AR-9 Prof. Parabellum V1.2
Twitter
Matrix
Source
