(Please read the print settings post first)
I made a variant of my Striker kinetic energy self-defense weapon that removed the keychain loop and is slimmer.
LBRY Tags: weapons; 3d printing; inventions
u/TumbleDryOnLowHeat · 2022-09-06 01:04:00 UTC · score 213
Well, I wasn't planning on posting this until it was done. But I started it this morning and it kinda got out of hand. I'm still working on the trigger mechanism and a few of the small details.
The Maus is a striker fired .22lr semi auto pistol.
Slide length is 100mm (4in).
10 round …
u/Grvin · 2025-03-12 07:07:56 UTC · score 5
Realistically it doesn't have to be super short, I would just prefer it be light enough that it can cycle on a striker fired without a booster assembly, which I think is a huge benefit of plastic suppressors. And I knew they had an ex lok to alpha threads for small diameter cans, but I didn't realize they had a 1/…
u/Res1cue1 · 2021-04-22 00:32:56 UTC · score 36
Here is my repriming setup. Here are the steps I use:
-
Remove anvil, I use scissor and tweezer/hemostat
-
Pound primer flat from where striker indents it
-
Fill with prime-all compound
-
Put a drop of isopropyl alcohol, I use syringe and angiocath as pictured above. This acts as hardening compo…
Flat Knife
Striker Pocket
Everyman Folding Knife
Twitter
Matrix
Source
