201
5
View this release
Alternative links
Gen6, rebranded RHS, built-in radiator style supports; released: 9 July 2025
Optional drop-in device which prevents the super-safety lever in the SSAUG trigger pack from overextending; prevents malfunctions where the lever 'catches' the trip slip, slowing down or even stopping the bolt from cycling. When printing, align either of the flat edges on the 'legs' of the retainer so that it appears as in the thumbnail from a bird's eye POV. This is the best orientation given the direction of forces applied to the part.
Optional drop-in device which prevents the super-safety lever in the SSAUG trigger pack from overextending; prevents malfunctions where the lever 'catches' the trip slip, slowing down or even stopping the bolt from cycling. When printing, align either of the flat edges on the 'legs' of the retainer so that it appears as in the thumbnail from a bird's eye POV. This is the best orientation given the direction of forces applied to the part.
Related to This Release
309
3
20250724 SCS Kabuto Housing Sqweeeeeeee
20250727_Rev1 - Reported range test of ~200 rounds, but user noted that housing was broken above pin hole when checked afterwards. Slightly adjusted …
103
3
SSAUG LtWt, Replenishable Drill Guide
9 June 2025
Some slight tweaks to reduce the amount of filament used for the SSAUG drill guide, as well as the ability to change the heads, using 2x…
1532
25
Gspot FRT Flat trigger shoe
Based off of Pembie's design - make sure you check out his original. he also has a flat faced trigger. just more options is better!
made a small up…
907
11
Kabuto Housing Cam Limiter
Had a problem with the SCS Kabuto cam dropping too low causing the bolt to get stuck in Semi mode. When the bolt was stuck the hammer could still dro…
620
28
Krrawn's Boarder SCS Trigger
This is an SCS trigger pack option for the NT-79 and Boarder.
Twitter
Matrix
Source
