1532
25
Based off of Pembie's design - make sure you check out his original. he also has a flat faced trigger. just more options is better!
made a small update and included a bambu .3mf file - to show the support orientation.
you should be printing this on the side, and supports are not needed. HOWEVER, if you print with supports on the slit of the trigger shoe .... while it's a pain to remove... you'll end up with a much smoother and cleaner trigger experience.
designer of the Gspot frt > @pembie000industries
3284
39
GSPOT GLOCK FRT TRIGGER PACK
updated files for flat faced trigger and converted reset to step file so that people can convert and modify as needed!
620
28
Krrawn's Boarder SCS Trigger
This is an SCS trigger pack option for the NT-79 and Boarder.
309
3
20250724 SCS Kabuto Housing Sqweeeeeeee
20250727_Rev1 - Reported range test of ~200 rounds, but user noted that housing was broken above pin hole when checked afterwards. Slightly adjusted …
154
7
Rounded Cut SS Trigger Jig
Saw that some SS vendors started cutting their triggers differently as a deterrent to potential accusations of having a part that is easily convertib…
Twitter
Matrix
Source
