251
8
View this release
Alternative links
This is an addon kit for the v3 mag stock.
There is a set of 90 deg latches and a set (including matching modified butt pad) with an additional 5 deg angle to the latch “hook”. Shown in green in the attached photo.
the three options for each angle are original, longer hook and longer hook with a stiffing rib.
You may need to scale them slightly for your particular printer to get that satisfying snap.
Heat bending may help depending on your print
Credit to @Heythere79 for the suggestion.
There is a set of 90 deg latches and a set (including matching modified butt pad) with an additional 5 deg angle to the latch “hook”. Shown in green in the attached photo.
the three options for each angle are original, longer hook and longer hook with a stiffing rib.
You may need to scale them slightly for your particular printer to get that satisfying snap.
Heat bending may help depending on your print
Credit to @Heythere79 for the suggestion.
Related to This Release
339
10
Lil Piglet Magazine Buttstock simple latch
A super simple printable latch for blue pandas Lil Piglet Magazine Buttstock
Same idea as blue pandas remix but the latch is now held in by the clam…
285
7
Lil Piglet Magazine Buttstock V3 Shorter LOP
Builds on the previous designs, incorporating feedback from @Heythere79:b the lop is shortened and some geometry has been tweaked.
If you already hav…
221
15
1
A2 Stock with spring latches
A rif on the a2 stock by unseenkiller to let you remove the butpad with a bullet tip or pen
uses a 6mm spring or 1/4 in, 50mm or 2in long mcmasterc…
353
13
Lil Piglet Magazine Buttstock simple latch with even more storage
After playing with the printed parts I realized I needed a spot for the wrench and that there was more unused space that we could use.
Now it holds 4…
237
18
1
BladeM2 Chopper, KAK Mini Buffer Tube Kit
This tool, when 3D printed, will make it easier to chop a Shockwave Blade M2 to seamlessly fit a KAK Industries' Mini Buffer Tube kit. Should one wan…
Twitter
Matrix
Source
