92 3

free pour flask

Rusty.sheckleford 13.7KiB Released March 4, 2025, 12:41 AM 0.001LBC 0 Reposts

View this release

Odysee

Alternative links

LBRY Desktop

this is a 3 part flask that you glue your free pour print to upside-down and then encase in plaster. use packing tape to seal all the 3 pieces together. pro tip: dip your part that you desire to cast in water with a drop of dish soap in it after you glue it to the base. it allows for lower srface tension when the plaster gets poured in and will result in less air bubbles.

Related to This Release

Release thumbnail

cam spruelet

Rusty.sheckleford

March 4, 2025, 12:15 AM

Accessory Pouring

this is to attatch to your casting tree. as all metals have different shrinkage rates this is at 100%. you will need to experiment with whatever meta…

Release thumbnail

7in sprue rod

Rusty.sheckleford

March 4, 2025, 12:19 AM

Accessory Pouring

this sprue rod fits in a 8 inch perforated flask for vacuum casting.

Release thumbnail

4in sprue rod

Rusty.sheckleford

March 4, 2025, 12:18 AM

Accessory Pouring

this sprue rod fits in a 4 inch perforated flask for vacuum casting

Release thumbnail

(Free-pour)THESAFETREEx6

Rusty.sheckleford

January 17, 2025, 9:53 AM

FRT Public Domain Remixable Sharable Accessory Pouring

ONLY USE THIS MODEL IF YOU ARE FREE POURING AND NOT VACUUM CASTING. YOU WILL GLUE THIS WITH A GLUESTICK UPSIDE DOWN IN THE FREE POUR CASTING MOLD I H…

Release thumbnail

lever spruelet

Rusty.sheckleford

March 4, 2025, 12:24 AM

the super safety lever to attatch on the sprue. print at 20% infill with the side of the lever flat againt the plate and support everwhere. it just s…