Join our Lemmy instance, now the official landing spot of /r/FOSSCAD
Release image
495 24
Author thumbnail

The Can-Can - Put a can on your MAC11!

Dinka Roubles 6.5MiB Released February 28, 2024, 11:33 PM 0.001LBC 3 Reposts
View this release Odysee LBRY Desktop
Share
Index Forum Twitter
9x19mm Cobray M-11/9 Accessory
The Can-Can is a 3D Printable direct-thread muzzle device for 1/2x28 threaded MAC11 pistol uppers, as can be commonly purchased through places such as JC Arms, MAF, Aves Rails, or Masterpiece Arms. The Can-Can will not thread onto the large coarse muzzle device threads found on some MAC uppers, but has enough clearance in the open end to pass over them and the large collar around the base of the barrel to sit flush to the face of the receiver.

The Can-Can is intended to exactly fill the interior volume of a standard 16oz energy drink can, which can then be modified to slip over the outside of the device like a sleeve for aesthetic purposes, but it will also provide a modicum of structural support.

---------------------------------------------------------------------------------------
THIS PROJECT WAS RELEASED FREE OF CHARGE UNDER A CREATIVE COMMONS ATTRIBUTION/NON-COMMERCIAL LICENSE.

You are free to share, use, remix, and do pretty much anything with this design, except sell it/put it behind a paywall, or scrub my name/logo off of it. Please see "license.txt" for more information.

***IF YOU PAID FOR THESE FILES YOU WERE RIPPED OFF AND NEED TO GET YOUR MONEY BACK!***

If you were charged for these files, please reach out to me
---------------------------------------------------------------------------------------

LBRY Tags: mac11; muzzle brake; 3d2a; printable; 3d printing