104
6
I needed an optic mount for my M11. My bolts weren't long enough to pass through @MiddletonMade 's optic riser and the rear top cap, so I smashed the files together into a single block and adjusted the holes to allow the same bolts as the original top cap.
Works with MnC V1 and @RiceCutta 's remixes of it. Should work with other remixes if they didn't change the rear top cap geometry, I can't guarantee that, though.
Print with the dovetail down, 99-100% infill, supports on.
LBRY Tags: m11; macncheese; middletonmade; sight riser
Works with MnC V1 and @RiceCutta 's remixes of it. Should work with other remixes if they didn't change the rear top cap geometry, I can't guarantee that, though.
Print with the dovetail down, 99-100% infill, supports on.
LBRY Tags: m11; macncheese; middletonmade; sight riser
Related to This Release
408
6
Mac n Cheese v2 Trunnion Seat for MPA Front Receiver Pin
These trunnion seats allow you to use a Masterpiece Arms 9mm Receiver Pin (MPA20-57) on your Middleton Made Mac N Cheeze v2
LBRY Tags: 3dprinted; g…
303
19
NN Strike Brace Remix ( With UMP 11-9 Adapter )
I designed this to fit onto my UMP but can be used for other Picatinny Rails! I also made this to be as simple as it can get! This is a Single Swivel…
399
9
Mac-N-Chese V1.5 Apple Pie fixed detent Grip
Middleton Mades Applie Pie grip for the Mac-N-Cheese V1.5. The detent pin is not in the right place for the Mac-N-Cheese V1.5, but proper place for A…
215
4
Krrawn Shroud Mac n Cheese Remix for Parts Dispensed Mac Upper
This remix is for the Parts Dispensed M11 upper receiver to fit the slightly longer trunnion.
LBRY Tags: fosscad; 3d2a; mac n cheese; guncad; krrawn
142
4
Middleton Made Mac N' Cheese Modded Rear Top Cap
Middleton Made Mac N' Cheese Modded Rear Top Cap
This was done to prevent the Mac upper from pivoting off the lower that I was experiencing (without …
Twitter
Matrix
Source
