465
16
View this release
Alternative links
This is a vertical foregrip inspired by Greco-Roman Pillars.
Magpul Mlok hardware is required to install.
Mlok is a registered trademark of Magpul, and this product is not endorsed by Magpul.
Use proper materials for this product, as a foregrip breaking off a short barrel and rapid fire are a bad combination.
This model is 60mm from the base.
-Update, This was originally released December 5 2021. The 40mm and 80mm model are now included as of April 6 2024
LBRY Tags: firearms; mlok; pillar; printable; stubbs
Magpul Mlok hardware is required to install.
Mlok is a registered trademark of Magpul, and this product is not endorsed by Magpul.
Use proper materials for this product, as a foregrip breaking off a short barrel and rapid fire are a bad combination.
This model is 60mm from the base.
-Update, This was originally released December 5 2021. The 40mm and 80mm model are now included as of April 6 2024
LBRY Tags: firearms; mlok; pillar; printable; stubbs
Related to This Release
1331
24
BPNVG Single Monacle Unit
This is the BPNVG single monacle body, and single monacle lens retainer, with the front sensor mount, gasket, and internal parts. Everything needed t…
1833
29
Laffs Picatinny Handstop V1.1.2
Laffs Picatinny Handstop V1.1.2: Laffs Dynamics
...It's a handstop that mounts to picatinny rails...
Were you expecting some deep lore?
Update V…
347
11
Rubber Duck M7 Bayonet
This is a printable dummy M7 bayonet for the Rubber Duck M16.
There is not a latch or any hardware needed for simplicity and safety.
LBRY Tags: m7…
3268
45
1
Pipe Hitter 37mm Launcher
This is an open source 37mm Launcher based on a linear firing pin design similar to cheap Cobray branded launchers.
This launcher uses a simple swing…
415
16
MP40 Buffer Adapter -Stubbs
This buffer adapter allows an original Maschinenpistole 40, or MP40 to use common modern 9mm ball ammunition in place of the substantially higher pre…
Twitter
Matrix
Source
