Link to AWCY's NT79- https://odysee.com/@AreWeCoolYet:7/NT-79:a

Link to the Replicant- https://odysee.com/@Bigbore729:b/Duplicator-title-page:7

Link to NT79 Faceplate mod- https://odysee.com/@Bigbore729:b/NT79-Mod:3

This is a remix of DaFizzlez's NT79. Changes listed bellow

The trigger guard snaps in the rear and is held in the front by an M3 Screw

The action lock area is thicker to add some more strength

The forearm is uses 2 M5x10mm screws and 2 M5 heat inserts

The stock pin holes are pushed back further from the edge to add more wall thickness on the stock

The stock inletting is optimized for duplicating on my DIY duplication machine the "Replicant"

The files contain a fully printed stock and forearm version as well as patterns for use in the Replicant duplication machine. These prints can have 3 walls and light infill. The blank mounts should be screwed to the wood you will use in the duplication machine and should be printed with 4 walls and 35% infill.

Follow AWCY's NT79 instructions for assembly and print settings.

LBRY Tags: nt79; guns; 2a; 3d printing; launcher