272
6
View this release
Alternative links
Lower front receiver for Middleton Made Mac n Cheese V1.5. This add 30mm length in the front rail to mount the Middleton Made Push Pop V1.1. Please note that the included Fusion (an/or .STP) file should be reviewed and altered to suit with YOUR UPPER. I had to make changes to fit my Parts Dispensed upper and make it sit flat on the rails. Use the history function in Fusion to see where the changes were made.
LBRY Tags: 3d2a; cantstopthesignal; 3dprint; 9mm; middleton
LBRY Tags: 3d2a; cantstopthesignal; 3dprint; 9mm; middleton
Related to This Release
399
9
Mac-N-Chese V1.5 Apple Pie fixed detent Grip
Middleton Mades Applie Pie grip for the Mac-N-Cheese V1.5. The detent pin is not in the right place for the Mac-N-Cheese V1.5, but proper place for A…
4305
41
Mac n Cheese v1.5 STEP FILES
● Please do not reupload the STEP files anywhere. Please link them to the listing you
found them at.
● Please refer back to my social pages if you ma…
142
4
Middleton Made Mac N' Cheese Modded Rear Top Cap
Middleton Made Mac N' Cheese Modded Rear Top Cap
This was done to prevent the Mac upper from pivoting off the lower that I was experiencing (without …
7201
62
1
Mac n Cheese v1.5 M11 Receiver
Updated files 12-1-21
The Mac n Cheese is a lower receiver file for the M11 9mm upper that uses an AR15 fire control group & magazine catch, and uses…
408
6
Mac n Cheese v2 Trunnion Seat for MPA Front Receiver Pin
These trunnion seats allow you to use a Masterpiece Arms 9mm Receiver Pin (MPA20-57) on your Middleton Made Mac N Cheeze v2
LBRY Tags: 3dprinted; g…
Twitter
Matrix
Source
