142
4
Middleton Made Mac N' Cheese Modded Rear Top Cap
This was done to prevent the Mac upper from pivoting off the lower that I was experiencing (without any prints breaking).
Print Settings:
- PLA Pro / Nozzle 220F
- 0.15mm Layer Height / 0.2 Initial Height
- 8-10 Walls
- 99% Infill / Line
- Normal Supports / Only Touching Buildplate
LBRY Tags: middletonmade; macncheese; 3dprinting; guncad; 9mm
This was done to prevent the Mac upper from pivoting off the lower that I was experiencing (without any prints breaking).
Print Settings:
- PLA Pro / Nozzle 220F
- 0.15mm Layer Height / 0.2 Initial Height
- 8-10 Walls
- 99% Infill / Line
- Normal Supports / Only Touching Buildplate
LBRY Tags: middletonmade; macncheese; 3dprinting; guncad; 9mm
Related to This Release
4305
41
Mac n Cheese v1.5 STEP FILES
● Please do not reupload the STEP files anywhere. Please link them to the listing you
found them at.
● Please refer back to my social pages if you ma…
2252
15
Mac n Cheese V1 - 3D Printable M11 Receiver
Can't stop the signal. Tag @Middleton_Made on social.
Have fun. Be safe. Stay free.
LBRY Tags: 3d print; 2a; liberty; tech; guns
272
6
Middleton Made Mac n Cheese v1.5 Lower Front extened for Push Pop
Lower front receiver for Middleton Made Mac n Cheese V1.5. This add 30mm length in the front rail to mount the Middleton Made Push Pop V1.1. Please n…
217
7
Invader Zip's Ark DIY Charging Handle Remix
Invader Zip's Ark DIY Charging Handle Remix.
This remix uses an M5 spring plunger instead of an M3 bolt and spring for the detent.
LBRY Tags: ark; i…
104
6
Rear Top Cap Optic Riser for Mac n Cheese / NWA
I needed an optic mount for my M11. My bolts weren't long enough to pass through @MiddletonMade 's optic riser and the rear top cap, so I smashed th…
Twitter
Matrix
Source
