FMDA DD19.2 v19.3 Remix: Mando Corser 4 PDW G19-F (SPLIT TO FIT 256MM PLATE)

STGMA 731.3KiB Released May 16, 2025, 9:50 PM 0.001LBC 0 Reposts

View this release

Odysee

Alternative links

LBRY Desktop

Hello all!

Firstly. This IS NOT MY DESIGN. This design belongs to @SumOne:5

I am uploading this because his version did not fit on my print bed but I made this version that has a dovetail so it can fit on the print bed and does not sacrifice the structural integrity of the print.

I have found printing this rails down is best since it causes the print to be much more stable, but you are welcome to print in the orientation that works best for you!

Will fit 256mm x 256mm x 256mm build plate

Please comment / provide feedback.

If you guys need any models altered, etc please don't hesitate to comment.

Remix of Mando Corser 4 PDW G19 F by @SumOne:5

DETAILS FOR THIS REMIX:
FMDA DD19.2 v19.3 Remix: Mando Corser 4 PDW G19-F
-G19 Gen.3
-Full Frame Grip
-Dove tail near rear pic rail to be able to fit on print bed
Corser Features:

-Reduced Grip Material and Grip Angle
-0 Deg. Offset on rear picatinny.
-Unexposed rear portion of slide.
-Extended slide cavity for enlarged rear baseplates.
-Slide rear baseplate adjustment pinhole.
-Notched rear trigger housing wall.
-Takes Gen.5 Take-down spring.
-PLA+ Friendly. "Fine" quality or better is recommended.
-Recommend Filament: PET-CF, PAHT CF, PPA-CF, or PPS-CF

Mando Features:

-7mm Raise on optic rail
-Optic rail inside top-face cut to Amerigo Ring Sight
-Added Spare Mag-well
-Right and Left side 7-slot Picatinny added
-Rear Sling point cavity cut for Blue Force Gear U-Loop
-For front sling point, use either side picatinny rail or front bottom rail
-Front rail system cut to use with 45mm diameter suppressors(heavy suppressor use with a PLA+ frame may cause warping).

Settings:

-Print-Orientation-Ready (however change to what works best for you)
-Use tree supports (I use organic)
-8-10 wall loops
-99% Gyroid Infill

LBRY Tags: 3d print; glock 19; mando; corser; full size