521
9
Simple jig for drilling a hole in a US dime to use as a breech for a 22lr gun. Place dime in the dime side, tape or flip, and use a 3mm drill bit in the hole. Ment for 22lr Rimfire. Can also be placed in a vice using the flat sides.
-nameisnight
LBRY Tags: 3d; 3d printed; art; gun
-nameisnight
LBRY Tags: 3d; 3d printed; art; gun
Related to This Release
1549
30
CMMG 22lr Bolt Catch
This is a clone of the Catch22 v1 bolt catch, its fully printable.
Use PLA+
100% Infill and print on side with catch up and with supports.
You may …
469
18
pERECTor
No description provided for this release
521
4
H22 prototype
This is the prototype H22 based off of Mussy's G22. It's designed to accept 12mm OD, 500mm long (1/2", 20" long) ECM barrels.
If you need mandrills/…
312
13
Another 3/4-10 Muzzle Device
A 30mm OD 3/4-10 muzzle device, made by request.
LBRY Tags: 3d printed; gun; fosscad; muzzle
244
5
22 Long Rifle
Don't dry-fire a rimfire gun, use a snap-cap. If you don't have one, print one of these. Unless you print ABS, I doubt it will hold up for long, but …
Twitter
Matrix
Source
