1549
30
View this release
Alternative links
This is a clone of the Catch22 v1 bolt catch, its fully printable.
Use PLA+
100% Infill and print on side with catch up and with supports.
You may need to sand the sides as if your printer is slightly out of spec.
LBRY Tags: 3d printed; cmmg; defcad; gun; 22lr
Use PLA+
100% Infill and print on side with catch up and with supports.
You may need to sand the sides as if your printer is slightly out of spec.
LBRY Tags: 3d printed; cmmg; defcad; gun; 22lr
Related to This Release
620
18
Adjustable Trigger, Trigger Guard
Replaces the trigger guard on an AR. An adjustable screw helps removing the extra pre-travel and post-travel of the trigger. This makes a mil-spec tr…
313
15
Trip Wire 209 Alarm Holder
A replacement for the holder for cheap trip alarms that came with out of spec holders, this one accepts 209 primers.
LBRY Tags: 3d printed; fosscad;…
297
12
37mm Dry Fire Dummy Round
Simple print to make a Dry fire safe 37mm dummy round, uses TPU for the "primer"
LBRY Tags: 3d printed; 37mm; fosscad; guns
3467
30
2
22LR Suppressor D1.2
22lr Suppressor
by nameisnight
Wanted to mess around with geometry and see if i could make a better baffle then the round ones normaly made.
We need…
734
13
Reflector 8mm Suppressor Project
Put pause in print at Layer 158 if printing in 0.2, insert 4 of the reflectors and resume print.
Hole ID is ~8mm so it might work for 32acp
not sure …
Twitter
Matrix
Source
