232
6
This is a 3D printable file for the factory 37mm caps that are used with CTS white smoke, CS, and CN rounds.
The file can be scaled up or down in your 3d printer slicer to achieve your desired fit, or to fit other shells.
It can be printed flat, or at a 45* angle.
There is a version with a curved bottom like the original, and one with a flat bottom for easier printing.
The file can be scaled up or down in your 3d printer slicer to achieve your desired fit, or to fit other shells.
It can be printed flat, or at a 45* angle.
There is a version with a curved bottom like the original, and one with a flat bottom for easier printing.
Related to This Release
705
17
Captain America Defrosted
This is a signal and agricultural flare launcher that is very easy to make assemble and use and is powered only by 209 primers.
LBRY Tags: fosscad; …
691
12
Rocket Derringer
Let's take a break from serious prints and build a rocket shootin' derringer. Total print time is less than 15 hours, only hammer needs 100% infill. …
405
12
Quiet Captain
The quiet version of the Captain America Signalling device. Ignore anything saying this is a beta, all files are tested and good to go.
LBRY Tags: f…
254
10
37mm stock
Fixed stock holds three 37mm shells. Made to fit mil-spec buffertube rather snuggly. small enough to print on ender 3 . Looks amazing on an nt79 with…
171
10
37mm face tuner
tool to square off and clean up the edge of 1-5/8" fence post. uses carbide insert tooling I have not tested this yet
Twitter
Matrix
Source
