the slip grip is a bump grip style accessory allowing you to effectively bump fire your ar15 by pulling forward on the handguard allowing it to reciprocate into the reset position then forced into the trigger finger sitting on the added ledge allowing repeated firing. requires 2 m3 screws for mounting grip to carriage and uses the oem grip screw to attach the carriage to the firearm.
u/iamnotazombie44 · 2024-06-06 18:13:53 UTC · score 32
Oh man, I know you are joking, but I just recently had a very scary accident that was traced back to an out-of-spec firing pin safety plunger on a G17 build.
Firing pin was hardened properly, the safety plunger was not.
After about 100 rounds the gun began firing doubles and not resetting (a…
u/Zastruguh · 2023-01-21 00:41:32 UTC · score 6
The first was to edit the frame in cad because the seer disconnect was flying up over that lip and into the slide, the model is on my odysee with the simple fix, all I did was make a rectangular chunk that sticks up so the bar has more to sit against under spring tension.
The second was to sand the very f…
u/Legoloser4 · 2024-06-04 17:14:35 UTC · score 1
I had an issue where the sear spring would slip out of place and dead trigger it. Also, make sure the screw that holds the grip in place actually went through the sear if it's out of place the sear will rest too low for the trigger to grab.
KD2 Grip (A)
bryco grips
PPS43 Grip
Twitter
Matrix
Source
