52
2
The button used for the folding brace seems to constantly fail on the same lip of the button retainer. To remedy this, I have added 2 channels for 6-10mm long M3 grub screws(choose a size based on how much you want sticking out the top). Applying a little heat to the grub screw makes screwing in the channels easier without cracking plastic.
LBRY Tags: 3d2a; ump11/9; remix; brace; leftfolding
131
6
7 and 10 degree fixed braces (boolibrace remix)
Simple fixed braces angled at 7 and 10 degrees, based of Booligan's Boolibrace. Uses 2 30mm m5 screws and 2 3mm deep nuts
LBRY Tags: 3d2a; 3d printi…
140
4
REMIX BALR Lower Receiver Reinforced Grip Screw
I added a slot for a M5 square nut in the grip so the screw is metal on metal and to avoid needing a tap set to install the grip. This is a similar d…
94
6
DEFIANCE GEN 2 GRIP (HWW REMIX 5mm SWELL)
grip with extra 5mm thick palm swell
LBRY Tags: guncad; defiance; grip
77
Intermediate 43R Shotshell Bambu A1 Ammo Factory Settings
This .3mf file combined with modded start/end gcode sequence will automate printing the Modelo Polytactico intermediate 43R shotshells on Bambu A1 or…
Twitter
Matrix
Source
