3
Round limiters for a PMAG-10 Gen 3 (AR10 308). This release has limiters for 2,3,4,5 rounds as well as an SCAD file you can use to make limiters of other sizes as well as for mags OTHER than a PMAG-10. You could even use it for AR-15 mags if you want. I recommend wrapping the limiter with duct tape to the bottom of the mag so that it doesnt rattle around and make noise since most limiters are used for HUNTING.
NOTE: DO NOT use this to limit a mag for your state unless the state's law allows temporary limiters because this is NOT a "permanent" round limiter. It can be easily removed. Most states allow temporary limiters for HUNTING purposes only (IE: Maine)
LBRY Tags: pmag10; guncad; limiter; round limiter; mag limiter
751
10
Canadian Legal/10 Round Limited DMB Glock Magazines
Canadian Legal DMB Glock Magazines
I've Modified the 9x19 DMB Glock Magazines to be legal with the current Canadian firearms laws. Our current laws…
78
5
SVTR DMB Picatinny Top (+2mm & +3mm)
Zero disrespect to DMB, just found that, in my opinion, the original pic rail top for the removable top mod was a little too close to the base to be …
72
6
38 Special Spiral Vase Ammo box 20 rounds
This is a 20 round 38 Special ammo box with all 3 pieces being printed in spiral vase mode.
This makes for quick prints that look good and only use…
34
4
1
winchester 68-22 rear sight round holder
If you have a old winchester 68-22 with a scope and the rear irons removed you can replace it with this. Holds 4 rounds, I drilled out the holes for …
Twitter
Matrix
Source
