Release image

Mac Daddy V1 Grip

Only Shells Remain 7.8MiB Oct. 23, 2021, 7:31 a.m.

No tags

Mac Daddy custom grip for original frame with socket at the rear for brace/stock adapters. I don't think this will fit the Mac Daddy remix with the Picatinny rails at the back, at least not properly.

For Mac Daddy Remix frame use this grip: https://www.thingiverse.com/thing:5028490

Grip is modeled to fit properly with "fuzzy skin" turned on in Cura slicer to give the grip texture, but still fit on the frame. GRIP WILL PRINT SMOOTH AND FIT LOOSE IF YOU PRINT IT WITHOUT FUZZY SKIN.
Fuzzy Skin - Yes
Fuzzy Skin Outside Only - Yes
Fuzzy Skin Thickness - 0.3mm
Fuzzy Skin Density - 1.25 1/mm
Fuzzy Skin Point Distance - 0.8mm

I keep the walls pretty thick - 2.8mm. Infill 60-65%, but it doesn't matter too much with the wall thickness.
Print with butt of the grip down on the build plate.

I printed the grip with Overture black PETG, so that it won't go soft when it gets hot.
For PETG, I set part cooling fan at 0%, 100% only for bridging.
I don't use supports for grips. A little cleanup is needed, but it won't ruin the texture as much as printing with supports.
Have your bridging settings squared away.

LBRY Tags: 3d printing; grip; mac daddy