View this release
Alternative links
Hinge is best print orientation (so far) has been on its side at .1mm layer height with touching bed only supports. Charging handle on its back at .12mm layer height with supports on touching bed only. Spring is printed vertically at .1mm layer height. Everything has been tested and successful. Be sure the 'clear out' any overhang in the charging handle spring hole with a razor or other tool. Also, press spring into hole and make sure it sets. All printed out of Inland tough PLA. Uses taper head m3 bolt and nut. I marked and cut down bolt to fit.
LBRY Tags: folding charging handle; usw; 19x
LBRY Tags: folding charging handle; usw; 19x