u/PrintingWithPEEK · 2021-09-20 06:58:26 UTC · score 23

Hello r/fosscad!

Here we are once again where it seems that the 3D Printing community has not gone past the Generation 3 barrier. I would like to gather data on this possibility and share some future insight and potentially inspire someone to bring this thought to fruition.

…

u/leylin877 · 2021-07-02 13:54:59 UTC · score 1

The p80 is pretty damn expensive. 99 for the 80% ~250 for internals. The 149 cost savings on the jig aren't huge if you make more than one. Plus it's back in stock last I'm aware.

Edit: never mind, they were in stock last night. Scalpers move fast.

Further edit: the same steps to figuring out a printable …

u/31spiders · 2023-06-02 19:56:54 UTC · score 1

Yeah I figured that. Remember when they made that “ghost gun law” where you could sell 80% OR the tooling in one box. (It was to thwart the P80 guys) That is when we stopped seeing flats being made by akbuilder. I wish they’d just make a “flat dimple press” and a “drilling guide” too. Just need to buy the …