View this release
Alternative links
FS-1 Rev 1: Laffs Dynamics
Revision of the original Laffs Dynamics FS-1 picatinny attachable buttstock. Much beefier than the original design; extra material around
the mounting section, much less material internally towards the rear.
Comes in two variants; a four slot mount and five slot taking advantage of some firearms having more picatinny rail space.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16
Wall Thickness: .40
Wall Perimeters: 7+
Infill: 40%+
Support Material Percentage: 18%
(Use infill blockers on the inside of the buttstock, as it is semi-hollow.)
Hardware Required:
2x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
2x M4 Hex Nut
LBRY Tags: 3d printing; firearms; picatinny; stock; revision
Revision of the original Laffs Dynamics FS-1 picatinny attachable buttstock. Much beefier than the original design; extra material around
the mounting section, much less material internally towards the rear.
Comes in two variants; a four slot mount and five slot taking advantage of some firearms having more picatinny rail space.
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 218C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16
Wall Thickness: .40
Wall Perimeters: 7+
Infill: 40%+
Support Material Percentage: 18%
(Use infill blockers on the inside of the buttstock, as it is semi-hollow.)
Hardware Required:
2x M4x30mm Bolt (Can be ground down to 28mm, so it doesn't stick out the side)
2x M4 Hex Nut
LBRY Tags: 3d printing; firearms; picatinny; stock; revision