View this release
Alternative links
Loose Change is a take on your normal fused pusher bases for @VanillaKyleKyle:c Modular Signaling System (MSS). For the guys running smokeless loads, especially in the many Hi/Low configurations out there, you may have noticed the increased pressure quickly shreds fuses and causes for failures to detonate. The nickel absorbs the primary blast to prevent this from happening.
Under the “Tolerance Testers” folder there is some test pieces to print out. You want the nickel to fit snug. Once you find the tolerance that fits best, print the corresponding pushers. It’s still recommended to put a couple drops of superglue on the pusher before seating your nickel.
Notice: These do add right at 5mm of protrusion from the base of the pusher into the casing space. Depending on the combination of your MILC/Hydra chamber and brass length, these might not fully seat without cutting your hybrid brass longer. Make sure you had the space required inside your case.
LBRY Tags: 37mss; 37mm; signaling; launcher
Under the “Tolerance Testers” folder there is some test pieces to print out. You want the nickel to fit snug. Once you find the tolerance that fits best, print the corresponding pushers. It’s still recommended to put a couple drops of superglue on the pusher before seating your nickel.
Notice: These do add right at 5mm of protrusion from the base of the pusher into the casing space. Depending on the combination of your MILC/Hydra chamber and brass length, these might not fully seat without cutting your hybrid brass longer. Make sure you had the space required inside your case.
LBRY Tags: 37mss; 37mm; signaling; launcher