View this release
Alternative links
Shark Fin M-Lok Handstop: Laffs Dynamics
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 38%
Support Material Percentage: 26%
Print the handstop upside down.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
LBRY Tags: 3d printing; firearms; m-lok; shark; fin
Printer Used: Ender 3 V2
Filament Used: PLA+
Print Settings:
Extruder: 220C
Bed: 56C
First Layer Print Height: .2mm
Standard Layer Height: .16mm
Wall Thickness: .40mm
Wall Perimeters: 6+
Infill: 38%
Support Material Percentage: 26%
Print the handstop upside down.
Hardware Needed:
2x M5x10 Hex Socketed Machine Screw/Bolt
2x M-Lok T-Nuts (Be sure both bolt & nut are the same thread pitch.)
LBRY Tags: 3d printing; firearms; m-lok; shark; fin