10
1
View this release
Alternative links
I had an old Honda valve cover laying around and decided to make it a key ring. Its a very simple but effective design.
Related to This Release
34
Winged Vortex UH1 Gen2 ARD
Killflash / ARD for Vortex UH1 Gen 2 but was given a Red Bull to ad some more security besides friction. You can print in suggested orientation or on…
85
5
Momo Steering Hub Cover
This was designed with my MK3 Jetta in mind and may not fit your specific use case. Please note that this removes the crushability of the Momo hub an…
42
3
TDB Hawk 250 Key
This is a key for the ignition cover on cg250 and gy6 bikes . You will need to press in 3 mm x 2 mm magnets matching the same polarity that your exis…
150
14
Gcode SquarePants Comp 1/2x28
Decided to make a comp a little different. a square comp ! short enough to allow the pressure to be pushed forward without breaking and still look co…
89
3
Taurus curve rear sight
Taurus curve pop in rear sight, once installed removing it will result in it breaking. Use 100% infill, only ever printed with pla pro not sure how o…
Twitter
Matrix
Source
