13
3
I created this upper support for those struggling to remove their barrel from their VZ61 upper. I could not find anything like this so I had to use it since my barrel was stuck in the upper. I used this printed support in conjunction with a 12 ton press and it worked perfectly without deforming the upper receiver or the printed support. Just slide this part in like you would with the bolt until it is up against the front trunnion.
I printed this completely solid with Esun PLA+. I included the STEP files in case anyone wants to remix it.
LBRY Tags: guncad; vz61
251
10
Decker 380 Barrel Liner Mount
This is the correct barrel mount for the Decker 380 when using a barrel liner. This is pulled from the .step file included and is intended to replace…
190
8
HitchHiker Rifle Length Barrel Alignment Tool
A quick alignment jig that goes around the storage lug. its the same height as the sights so you can press everything down on a flat surface to align…
83
5
9mm Handgun - Barrel Wall Mount
This is a wall mount for 9mm handguns.
39
4
Handgun Wall Mount - .45 Barrel
This is a barrel wall mount for handguns with a .45 caliber.
Twitter
Matrix
Source
