929
16
1
I wasn't happy with any of the build options so I designed this brace to be used with the urutau. I tried to keep the structural integrity of the rear cap while allowing the ability to use a brace. It should just be a drop in replacement for the parts that are normally in the build guide. The only other piece of hardware needed is an m4 bolt for the brace arm. It was a little difficult to get the distance between trigger and end of brace to be under 13.5 inches (alphabet rule?) but measurements in cad show it to be comfortably under. This is still technically in beta so use these files at your own discretion/risk. I have included the STEP files as well for anyone that wants to try and improve or alter the design.
LBRY Tags: cad; 3dprinting; fosscad
LBRY Tags: cad; 3dprinting; fosscad
Related to This Release
1668
16
Urutau Rifle Length Handguard
A rifle length handguard for the Urutau
295mm long so it should be printable on a 300mm sized printed
OG files here
https://odysee.com/@Plaboi:…
1210
13
Grippy Extended Urutau Handguard
A rif on my prior extended handguard. Adds slots up top to provide better flashlight wire routing and additional mounting locations.
While the flashl…
702
18
Urutau Internal Flashlight Mount
Internal flashlight mount for extended Urutau handguards
Fits 22-29mm flashlights
secured with 5x m3 screws
route your switch wires through one of t…
700
15
Urutau Brace Options Beta
Couple options for braces, a standard buffer tube nub for a tailhook style brace and a wedge style.
designed for trenches so i haven't printed it, he…
385
9
Urutau Simple grip plug
simple plug for the Urutau grip, helps keep stuff out. works in conjunction with the top plug release as storage thats only available when the halves…
Twitter
Matrix
Source
