This is to replace the spring in the Pembleton designed V2 with spring hole shoe! This is meant to be printed with a TPU filament with a shore rating around 80-90.
Use default slicer settings for generic TPU with exceptions of:
Layer height: .1
First layer height: .1
Walls: 3
infill: %100
rectangular infill pattern.
Happy printing! -For the sake of science!!
LBRY Tags: gfrt; frt; guns; gun; glock
u/Ilati · 2022-09-10 23:27:02 UTC · score 1
Hello, I realize I'm a bit late to this thread but I just put mine together piece by piece as well. I bought a Timney trigger and had to get a safety plug assembly put together. I put the Safety Plug from the CZ site but the one you linked looks to be the same.
Note that if you look at the Evo schematics you'll al…
u/MakeItMakeItMakeIt · 2024-11-16 03:34:55 UTC · score 3
I did mod it by changing the exit angle. I modeled up a little shroud that holds a PTFE push-connector, and it sits on top toward the back, letting the filament be more easily pulled off the spool. Cut a new opening where the shroud sits, the original holes stay sealed with the rubber plu…
u/OG_Fe_Jefe · 2022-09-26 03:51:10 UTC · score 2
Install a gas block that has the outlet tube plugged.
Easiest way is to drill out to an appropriate size and plug with threaded bolt, or for a neater appearance a set allen or grub screw. Install with locktite type thread sealant, mechanically caulk (peen the threads) to make the install permanent on…
DB ALLOY GLOCK MAGAZINE CARRIER
Small Glock speed loader
RMR Cap Sights V1.1
Twitter
Matrix
Source
