221
10
View this release
Alternative links
Hardware required: 2 socket button head cap screws M3 and nuts
Use: Start with a standard 2 handed grip, then move your thumb of your off hand forward till you can apply inward and downward pressure on the thumb grip with your other fingers on the opposite side. Be careful not to ride up too high on the grip as to avoid discomfort from contact with the moving slide.
Use: Start with a standard 2 handed grip, then move your thumb of your off hand forward till you can apply inward and downward pressure on the thumb grip with your other fingers on the opposite side. Be careful not to ride up too high on the grip as to avoid discomfort from contact with the moving slide.
Related to This Release
672
12
Springfield XD9 diamond patter grip
Springfield XD design with diamond pattern grip. Frame is not my design, I just added grips
LBRY Tags: springfield; xd9; 3d2a
63
2
Mona Left DB Shadow Grip Panel
Recommended to print with model stood up and tilted 15 degrees to the right, tree supports, and finer layer height. Model has been printed and has co…
370
11
Kriss Vector Angled Fore Grip (AFG)
An angled foregrip for the Kriss Vector, styled after the Magpul AFG.
LBRY Tags: gun; 3d print; guns; magpul
497
16
furikake v1.5 11.5" & 16" shroud (beta)
these 2 shrouds are compatible with all hardware from the main release just intended to give the longer barreled uppers a place to live
192
8
Folding Grip w Pressure Switch Mount
Folding grip with pressure switch mount
LBRY Tags: 3d printing; diy
Twitter
Matrix
Source
