My version of the 2 piece Incognito Sear for all G🔒 frame sizes excluding slimline! (View my Slimline model posted on my page)
Very similar to other 2 piece designs but probably the best out at the moment.
Best fabricated in metal but reinforced polymer printing can be functional.
Design tested and confirmed working on many G🔒 models and clones.
For smaller frames some sanding to the disconnect may be required for effective FA fire

Changes include:
Entirely new disconnector profile (Lengthened, widened, and curved)
OEM like backplate with cover for disconnect when installed
Added disconnector retainer that interacts w/ firing pin assembly

Tuning instructions: If the disconnector is not going into battery that means it's too long, do NOT force it into battery, just rack the slide a couple times to leave an imprint on the disconnector. Afterwards remove the disconnector and you will see the part that's stopping it from going into battery sand it down following the same curve until the imprint goes flush/away. Round it into a butter knife style like how it originally was once printed, you are just removing some material so it pushes the trigger bar downwards enough. Now if you did this correctly, rack the slide to the rear using the slide lock, pull the trigger and release the slide forward and it should fire when it returns to battery.

SAND AND FILE VERY SLOW FOR THIS TO WORK, IT REQUIRES VERY VERY IMPORTANT AND SMALL FITMENT TO WORK

LBRY Tags: auto sear; fflsot; glock; guncadindex; nnwdev