29
5
One of the problems I seem to encounter whenever I use printed magz is that the plate starts to slip off or even breaks and bends at the lip due to pressure of pushing down when enough shells are loaded and this is the revised double lip but still does it. If you use for an example 17 rd. clip but only load 5 or 8 than there's no issue. At the moment I have fully loaded 17 and is holding good so far with this somewhat ok job I just put together. I figured why not share.
LBRY Tags: glock magazine; dmb; mag; magazine plate
1854
36
1
Glock Mag Release, Gen 3 - Extended Catch V1
Tired of your mags falling out? Need something with a tighter tolerance? These might help (or they might not). Original .STP I remixed from is includ…
445
7
2
Extendo Glock Mag Sleeve
Fits glock 33rd mags.
353
10
2
Glock Slide Wings
A replacement backplate for full size Glocks. Adds a wing on either side, not unlike a standard AR charging handle. Allows for easier slide manipulat…
27
3
RMR Cap Sights V1.1
getting back into doing this, thought id get something out of the archives and release it by itself.
LBRY Tags: glock; sights; rmr
Twitter
Matrix
Source
