311
12
1
View this release
Alternative links
These are meant for double stack 9mm glock mags.
The Hardware used to complete this was purchased from Holster Builder. Its cheap stuff and if you get a few belt clips and some hardware under 20 bucks you can make a few of these. If your first print seems tight simply scale it up to 101 percent .. every printer is different and I made this to fit a glock mag perfectly snug.
Hope you like it!
The Hardware used to complete this was purchased from Holster Builder. Its cheap stuff and if you get a few belt clips and some hardware under 20 bucks you can make a few of these. If your first print seems tight simply scale it up to 101 percent .. every printer is different and I made this to fit a glock mag perfectly snug.
Hope you like it!
Related to This Release
149
6
skully9-mag-holster
a magazine leg holster for the skully9 magazines
LBRY Tags: skully9-pdw
211
3
buckmark Holster V2
version 2 of the buckmark holster, better suited for thicker grips.
118
9
Gunsmithing Punch Tray
A tray for holding brass punches, specifically designed with the Spika Guncare Punch Set, sold on Amazon, in mind. Holds 10 3/8" wide brass punches a…
106
6
Novelty Chamber Flag
Novelty chamber flag to express your opinions about some range's requirement to use one.
1148
46
Target Clip V3.1
The Target Clip is designed to hold cardboard targets to 0.375” rebar.
Cardboard with a thickness of 0.100” to 0.125” is recommended. The clip is pu…
Twitter
Matrix
Source
