59
6
Can be printed vertically, but can crack. I've been printed horizontally at .16mm layer height with support everywhere and brim bed adhesion. Attaches to Ozark Armament pistol flashlight. Hashtag for the poors.
Related to This Release
85
8
GoonBeamARD
Anti-Reflective Device for your Goon Beam flashlight. Requires approximately 6" of 3mm elastic cord.
LBRY Tags: flash light; ard; goon beam
88
6
USWSolidSideCharge
Back plate printed vertically at .1mm layer height on nut side down with supports on. Charging handle printed on back with supports at .1mm layer hei…
63
4
CrescentCharmHolderv2
A quick little stand for a few of @RubyGraceBuilds:f charms. Wonderful way to show off your multicolor filaments, as opposed to a flat swatch.
LBRY…
49
4
GoonBeamMounts
MLok mounts for your GoonBeam. Flat and 45 degree angled mounts. Uses m4x10mm bolts and amazon special mlok t-nuts.
https://www.goonbeam.com/
LBRY…
40
6
BooliganPicatinnySightMount
**REQUIRES some small ass Philips screws. I used some off an old ender fan
LBRY Tags: picatinny; usw; at home; fmda 19; scope
Twitter
Matrix
Source
