988
23
View this release
Alternative links
Don't you just hate it when you pull the trigger on your FGC-9 and hear a loud snap?
There goes the hammer, having snapped at its weakest point, right where the screw goes.
Solution?
Throw the hammer's STEP file into FREECAD and pad its lateral parts by about 1,3mm.
The end result is a little heavier and far more robust.
Tried and successfully tested!
LBRY Tags: fgc-9; 3d printing
There goes the hammer, having snapped at its weakest point, right where the screw goes.
Solution?
Throw the hammer's STEP file into FREECAD and pad its lateral parts by about 1,3mm.
The end result is a little heavier and far more robust.
Tried and successfully tested!
LBRY Tags: fgc-9; 3d printing
Related to This Release
1279
27
FGC-9 MK1 RIP Edition v1.1
RIP JStark1809 you will not be forgotten
271
7
FGC9 Upper for Sten MKII Barrel
I had a Sten (Mark II) barrel laying around and discovered that the OD of the locking ring fit really nicely in the FGC9 receiver, but the chamber en…
215
9
FGC-9/CSGCG More Printable Safeties
I love the FGC-9 and I love the CSGCG, but the safety doesn't really have an orientation that I'd call "printable". So these levers fix that. They're…
854
13
FGC-9 Mk2 Bolt Housing remix
Here is a small improvement on the FGC-9 bolt housing, added a lip to sit the recoil spring. Intented fo be used in a bufferless FGC-9 but should fit…
1252
10
ImmortalRevolt's FGC 9SD v2.2
yep its about that
Twitter
Matrix
Source
