55
3
2
The Backstrap Molasses AR-15 grip has a grip angle of only ~10 degrees from perfectly vertical. Normally, this would place the hole for the screw right in the middle of the backstrap, so I made that a separate piece that is pressed into the front portion after it is screwed onto the receiver. This also allows for multicolour grips with a low cost printer like an Ender 3 or to print the backstrap out of a flexible material like TPU for added comfort.
LBRY Tags: guns; gun; firearms; firearm; ar-15
1181
14
Sentinel Kurz Grip (AR-15)
Sentinel Kurz Grip (AR-15): Laffs Dynamics
Compact variant of the revised Sentinel AR-15 grip. Retains front and rear ridges for ease of retention i…
1025
18
HubTN.4 - 9mmL, open beta (v5)
Open beta for the 9mm Long variant in the HubTN.4 series. HUB as well as 3/4x16 versions are included.
v2 Update: A smooth step file was added for S…
263
10
DB9 Alloy Lower Remix "DUMP9A"
This is the lower alone from my DUMP9a "DUMPster Fire" release. It has three different lower variations: OG, SS, Carbon Side Plate. This will work as…
13
Shock cord BILEAF scope cover light cover 66mm
Where is the line between remix and reverse engineering? Hell if I know, but I didn’t hide my work.
66mm scope objective bell diameter (true ID 69m…
Twitter
Matrix
Source
