222
11
A simple wall hanger for an AR15 (or any other rifle that uses the same or similar magazines) and two mags. Mag boxes accept STANAGs and Pmags, but the Pmags need to be butt-up, the wide bottoms won't fit. Attaches simply with common wood or drywall screws. Would be good to mount inside a closet or near a bed for quick access in case of a home invasion.
I print these with three walls, 25% infill, Cubic, and they come out plenty strong.
Print sitting the right way up with supports. Tree supports work best, as regular supports can be a little tough to remove from between the mag boxes. Expect a print time of about 24 hours at Standard Quality.
I print these with three walls, 25% infill, Cubic, and they come out plenty strong.
Print sitting the right way up with supports. Tree supports work best, as regular supports can be a little tough to remove from between the mag boxes. Expect a print time of about 24 hours at Standard Quality.
Related to This Release
1087
28
Bushing Installation Tool
This is the tool used to pull the brass bushings into their pockets.
LBRY Tags: ar15; hoffmantactical; bushing
615
30
Nut Launcher V2.0
The Nut Launcher is a brand new type of firearms accessory. Enjoy!
LBRY Tags: ar15; launcher; nuts; hoffmantactical; 3dprinting
623
24
AR15 Push Button Safety
My first fusion project so please bare with me ,
Message and follow me on IG @310_2A if any questions
LBRY Tags: guncad; 310_2a; ar15 safety; ar15…
837
5
Hellfire trigger
Hellfire trigger actuator
290
8
BAD Lever Clone
Nearly free BAD Lever
Features:
Can be slipped on (potentially more persuasion required)
Can be pushed down to drop bolt. (duh)
Can be pushed up to…
Twitter
Matrix
Source
