View this release
Alternative links
CHAIRMANWON GLOCK V3
-------------------------------------------------------------------
Files are not released under any liscense. Commercial use is not premitted without my express consent.
-------------------------------------------------------------------
BTC donation address bc1q705fcdq9l5l4qdst76e24k4svltt5drnpsth59
-------------------------------------------------------------------
website can be found at origamifaceshield.com chairmanwon.com or chairmanjuan.com
-------------------------------------------------------------------
DO NOT USE ANY NOZZLE LARGER THAN .4mm THERE WILL BE HOLES IN THE PRINT IF YOU DO
-------------------------------------------------------------------
Printing Profile Notes
Support X/Y Distance: 1.3mm (stops Cura from supporting stipples)
Use tree supports instead of normal supports (if you are suffering from very long slice times switch back to normal supports, you will waste material compared to trees but the print will be fine)
If you are using Prusa Slicer make sure you have Detect Thin Walls set to off
Nozzle: 0.4mm
Layer Height: 0.16mm
Temp: 215-230/60C
Infill: 100%
Walls: 8
Supports: On/full - use a close support interface gap. Your interface gap should not be larger than 0.16mm unless you know what you are doing with your setup.
Cooling: As low as you can get away with for your printer
All other settings can/should be left as default or whatever you know works best with your printing setup.
-------------------------------------------------------------------
Files are not released under any liscense. Commercial use is not premitted without my express consent.
-------------------------------------------------------------------
BTC donation address bc1q705fcdq9l5l4qdst76e24k4svltt5drnpsth59
-------------------------------------------------------------------
website can be found at origamifaceshield.com chairmanwon.com or chairmanjuan.com
-------------------------------------------------------------------
DO NOT USE ANY NOZZLE LARGER THAN .4mm THERE WILL BE HOLES IN THE PRINT IF YOU DO
-------------------------------------------------------------------
Printing Profile Notes
Support X/Y Distance: 1.3mm (stops Cura from supporting stipples)
Use tree supports instead of normal supports (if you are suffering from very long slice times switch back to normal supports, you will waste material compared to trees but the print will be fine)
If you are using Prusa Slicer make sure you have Detect Thin Walls set to off
Nozzle: 0.4mm
Layer Height: 0.16mm
Temp: 215-230/60C
Infill: 100%
Walls: 8
Supports: On/full - use a close support interface gap. Your interface gap should not be larger than 0.16mm unless you know what you are doing with your setup.
Cooling: As low as you can get away with for your printer
All other settings can/should be left as default or whatever you know works best with your printing setup.