95
3
1
Glock 43X pattern frame using 43.1 rails. Standard picatinny acessory rail. PA6 CF/GF recommended. print rails down tilted 12 degrees with the nose down for best results. Remix of an AA13 design. Extended slide lock required.
LBRY Tags: 3d2a; 43x; glock; frame; glock 43x
874
15
Long Rider Picatinny Rail
Want to add a small optic rail on the Long Rider body kit? Here you go. This fits well with M4 flat head countersunk screws.
LBRY Tags: 3d printing
146
9
Glock EZRAK gen 1-4
GLONK EzRak i made , kinda minimalist, not to bulky and still works. i put a picture for scaling just in case. for some reason when its in slicer it …
68
6
SVTR Picatinny Rail End Cap 4-slot
Enjoyed the ability of the pic rail on the original release however personally found it needed a few more rail slots to really be usable. No disrespe…
28
2
P38 slide retainer lever detent pin
Detent pin for the takedown lever / slide retention lever. I was missing one and modeled it based on an image on Numrich and measuring the hole. Test…
Twitter
Matrix
Source
