View this release
Alternative links
AR-VAL 3D-printable stock, will require a printer with at minimum 330mm of Z-axis travel for tested print configuration.
Designed to be printed as 1 single piece, will require additional components:
1x M10x200mm threaded rod
1x M10 cap nut
1x M6x16 point-tip grub screw
1x MAGPUL PRSII Recoil pad
2x 1/4-20 x 5/8" Flathead bolts
This work is licensed under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-sa/4.0/ or send a letter to Creative Commons, PO Box 1866, Mountain View, CA 94042, USA.
Designed to be printed as 1 single piece, will require additional components:
1x M10x200mm threaded rod
1x M10 cap nut
1x M6x16 point-tip grub screw
1x MAGPUL PRSII Recoil pad
2x 1/4-20 x 5/8" Flathead bolts
This work is licensed under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc-sa/4.0/ or send a letter to Creative Commons, PO Box 1866, Mountain View, CA 94042, USA.