123
3
View this release
Alternative links
The Decker's BOM calls for the bolt tube to be cut to 100mm exactly. If cut perfectly, this length should require zero headspacing (the bolt should headspace off its printed face.) If the bolt tube is cut a little long, you can compensate by adjusting the headspacing bolt. However, if the tube is cut too short, then proper headspacing will become impossible and light strikes will result.
To address this, I have created modified versions of the Decker bolts. These bolts have slightly bolt tube holes, allowing a shorter bolt tube to protrude further.
Note that the bolt tube is squared to the bolt body by the bolt hole itself. The shallower the hole, the more out-of-square it's possible for the tube to become. For the +2mm bolt body, this probably isn't a problem, but it might become a problem for the +4mm body. That said, if your bolt tube is cut so short that it needs a +4mm compensation, then you should probably just get a new bolt tube.
Two bolt bodies are included:
* One that reduces the hole depth by 2mm - use if your bolt tube measures between 98mm and 100mm
* One that reduces the hole depth by 4mm - use if your bolt tube measures between 96mm and 100mm
Email us at customersupport@3dprintfreedom.com with any questions. Thank you!
To address this, I have created modified versions of the Decker bolts. These bolts have slightly bolt tube holes, allowing a shorter bolt tube to protrude further.
Note that the bolt tube is squared to the bolt body by the bolt hole itself. The shallower the hole, the more out-of-square it's possible for the tube to become. For the +2mm bolt body, this probably isn't a problem, but it might become a problem for the +4mm body. That said, if your bolt tube is cut so short that it needs a +4mm compensation, then you should probably just get a new bolt tube.
Two bolt bodies are included:
* One that reduces the hole depth by 2mm - use if your bolt tube measures between 98mm and 100mm
* One that reduces the hole depth by 4mm - use if your bolt tube measures between 96mm and 100mm
Email us at customersupport@3dprintfreedom.com with any questions. Thank you!
Related to This Release
293
6
.380 Decker Firing Pin Sleeves
The Decker's BOM calls for its firing pin to be cut from 1/8" stock to 127mm long. Even if cut perfectly, I have found that sometimes this length is …
137
8
Decker Bolt Thru 1.0.2
Bolt-Thru version of the Decker 380
Do you hate having to screw the threaded rods the full length of the assembly slowly and painstakingly so you do…
1711
12
FGC9 MKII (Slim)
This is just a minor project that aims to shrink the fgc9's height over bore without changing the internals, assembly is the exact same as a normal f…
553
12
26M bolt V2
The 26M bolt is a bolt for the FGC9 MKII which requires no metal machining. This new version tries to solve the buldged primers problem found in the …
424
10
BETA: A1/A4 hybrid upper
this is an A1 slick side upper with a shell deflector and a pic rail. It uses a1 style rear sights. it would need to be CNCed in aluminum to work
Twitter
Matrix
Source
