Release image

Scout's SmolStop Handstop

Scout339 1.6MiB May 14, 2024, 11:58 a.m.

No tags

Scout339's 'SmolStop' Hand Stop, inspired from Driven Arm's ShortStop.

Requires 1x T-Nut for MLOK.

For duty-grade strength, I recommend 6 walls and 50% infill. I've tested it with ASA, but PLA+ and PETG should also work, and any Filled Nylon (and possibly filled PETG? I haven't tested that enough though) will be even stronger.

Print with MLOK slots facing buildplate (upside-down) or at a slight angle for best results.

Fuzzy Skin Settings used in second picture are as follows:
0.1mm layer height
0.2mm thickness
6mm density

Happy shooting!

----------

Licensing:

The SmolStop by Scout339 is licenced as follows:
Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike

https://creativecommons.org/licenses/by-nc-sa/4.0/

LBRY Tags: grip; mlok; handstop; file; 3dprinting