So, you seem like you are in the right track.

Use a 1/4" drill bit as a mandrel to hold the beginner shells for sanding.

For intermediate (or any upcoming load that uses small primers) you use a T25 Torx bit as the mandrel. I recommend a new one with crisp edges. You can also use the torx bit after smoothing the cases to ream out the primer pocket to size.

The beginner loads use a 209 primer. The 209 primers protrude out the back of the ca…

u/Pm_Me_7_62x39 · 2022-04-15 17:53:44 UTC · score 2

Are you using the FRT? the disconnector needs to be filed down some if so.

​

Edit- I found a good way to test this is taking your rear takedown pin out, it should allow you to pull back without binding if this is the issue. In my case as soon as the rear takedown pin was engauged the bi…

u/AndYouMayCallMe_V · 2021-08-20 21:31:26 UTC · score 10

Hey! Got a ton of requests to do a preorder for the uppers, and while this isn’t a preorder yet, this is a google form to help me gauge an initial run size. If you’re interested in purchasing one in the next two months, please fill it out and share!

https://docs.google.com/forms/d/e/1FAIpQ…