View this release
Alternative links
Don't you just hate it when you pull the trigger on your FGC-9 and hear a loud snap?
There goes the hammer, having snapped at its weakest point, right where the screw goes.
Solution?
Throw the hammer's STEP file into FREECAD and pad its lateral parts by about 1,3mm.
The end result is a little heavier and far more robust.
Tried and successfully tested!
LBRY Tags: fgc-9; 3d printing
There goes the hammer, having snapped at its weakest point, right where the screw goes.
Solution?
Throw the hammer's STEP file into FREECAD and pad its lateral parts by about 1,3mm.
The end result is a little heavier and far more robust.
Tried and successfully tested!
LBRY Tags: fgc-9; 3d printing