View this release
Alternative links
the FGC-6BL is here making this the first hammer fired semi auto GBB FGC-9 airsoft replica to be released. there will be later also a FGC-6H this will be the 1 on 1 replica in function and handling from the FGC-9. but the BL is very close to this as well the only difference is that the bolt will be partly open when the last round have been fired.
I can’t make any guarantees of course since the FGC-6H is not finished but the idea is that you only need to reprint the BOLT, HAMMER, and some small disconnect parts to switch between the FGC-6BL and the FGC-6H
this kit comes with a lot of options! so read the PDF’s well before you start so you know what to select to print and buy.
this project have been tested with green gas, red gas and HPA and it got a working range with the current springs of 80/90 up to 140 Psi on HPA.
look for shrouds and stock in the FGC-6BL MKI or MKI collections
FGC-6BL MKII links
https://www.printables.com/social/180009-untangleworks/collections/492099
FGC-6BL MKI and Hybrid
https://www.printables.com/social/180009-untangleworks/collections/492098
the advanced parts will be released in a separate package. note: only use them as fine tuning and experiment parts! your FGC-6BL should work with the parts provided in this starter kit.
movie link:
https://youtu.be/RN40G9kLlGs
print settings:
0.2 layer hight should be fine.
you can use the 8 layer walls and a 40% infill.
but personally I moved a bit over to solid prints just to give it more strength in case things go wrong on the field…
for the lower I would use a brim on both the outside and inside the part just to prevent it from warping
LBRY Tags: airsoft; fgc-6bl; fgc6; fgc6bl; gbb
I can’t make any guarantees of course since the FGC-6H is not finished but the idea is that you only need to reprint the BOLT, HAMMER, and some small disconnect parts to switch between the FGC-6BL and the FGC-6H
this kit comes with a lot of options! so read the PDF’s well before you start so you know what to select to print and buy.
this project have been tested with green gas, red gas and HPA and it got a working range with the current springs of 80/90 up to 140 Psi on HPA.
look for shrouds and stock in the FGC-6BL MKI or MKI collections
FGC-6BL MKII links
https://www.printables.com/social/180009-untangleworks/collections/492099
FGC-6BL MKI and Hybrid
https://www.printables.com/social/180009-untangleworks/collections/492098
the advanced parts will be released in a separate package. note: only use them as fine tuning and experiment parts! your FGC-6BL should work with the parts provided in this starter kit.
movie link:
https://youtu.be/RN40G9kLlGs
print settings:
0.2 layer hight should be fine.
you can use the 8 layer walls and a 40% infill.
but personally I moved a bit over to solid prints just to give it more strength in case things go wrong on the field…
for the lower I would use a brim on both the outside and inside the part just to prevent it from warping
LBRY Tags: airsoft; fgc-6bl; fgc6; fgc6bl; gbb