Biden's Bane 3D Printable AR15 Upper Receiver

This release either contains or is a DIY upper receiver assembly -- the part with the barrel, bolt, and maybe part of the recoil system.

Uppers are oftentimes unserialized, but not always, such as in the case of the MP5.

Guns with a non-hand point of contact that fire rifle cartridges. For the purposes of this index, full-length rifles and carbines are in the same category.

Matches all of the AR-15s, including all carbine and rifle variants, the M16, bullpup conversions, and generally anything that takes the gas system, bolt assembly, and barrel off of one.

DOES NOT match things that take AR-15 FCGs and does not necessarily imply as much.

(LEGACY TAG: TO BE REMOVED)

Anything that would be considered by the ATF to be the frame or receiver of a firearm and thus require serialization. This tag is only for kit builds, not for hybrid releases like the FGC-9 which take no gun parts.

Releases like the Orca, ARK, Bobcat, and similar are frames/receivers since they still require off-the-shelf gun parts.

It's a thing that shoots a projectile out of a barrel. Also refers to just the serialized parts of those devices, where applicable.

Patrick, that's a gun.
<Yes.

The Gatalog, formerly Deterrence Dispensed. One of the largest GunCAD groups out there.

They opt for long development times and rigorous documentation/testing standards.
Visit their website thegatalog.com to connect to their RocketChat for testing and questions.